Accessing your Network Development Group courseware with access codes

To access your courseware on NDG, you must first retrieve an access code. This code is automatically assigned to you when you click on your course materials in your BibliU Library. Follow the steps below to ensure you receive your access code and can start using NDG for your studies.

Instructions:

1. After logging into the Cisco Networking Academy, learners will see the added course.

a. From the My NetAcad page, select the I’m Learning tab.

b. Click the course that you wish to access

2. Once in the selected course, learners will access the course content.

a. Click Modules on the left side of the screen.

b. Select a module and click on it.

c. Load the chapter in a new window.

3. The first time the course is accessed, learners will be prompted to accept terms and conditions of the course.

4. After accepting the Terms and Conditions, learners will be prompted for an access code. Students: If entering a code that you received from your institution or already purchased from

5. Learner enters access code into course.

6. Learner now has access to course materials.

All NDG Linux course questions should be directed to Network Development Group Online Support at hostedsupport@netdevgroup.com or you can visit https://support.netdevgroup.com/hc/en-us/categories/200290878-NDG-Online-Portal 

You can also reach out to support@bibliu.com for further assistance with regards to your access codes.